If your looking for an exciting and rewarding career in the building and renovation field then look no further than vapor blasting. This exciting method offers unlimited benefits and can be used for a variety of projects. To begin with you must understand the techniques that are used. In a nutshell vapor blasting is a technique of utilizing pressurized air or other heated substances with a high pressure stream to thoroughly clean and rejuvenate factory finished products, factory unpainted surfaces, and stripped metal components. For example any metal component that is being coated for an exterior finish will require vapor blasting. The next step in a vapor blasting operation is to apply the blasting fluid to the item being finished. You will need a machine gun to accomplish this. A machine gun consists of a pump that shoots a stream of compressed air at very high speeds. While pressurized air is used in a vapor blasting operation the actual abrasives being used are typically anodized aluminum oxide block abrasives. Aluminum oxide block abrasives are good because they are highly resistant to abrasive flow and abrasive removal. The block is also inert and will not draw moisture from the surrounding areas. Other types of vapor blasting anodized blocks include copper oxide block and carbon dioxide abrasive. The difference between these two abrasives is their chemical properties and how much of each type of abrasive is needed to achieve the desired surface finish. When using a vapor blasting system it is important to know what parts surfaces you are going to work on. The part's surfaces may range from steel, aluminum, sheet metal, wood, plastic and more. It is usually a good idea to do some research on the particular parts surface you are going to work on to ensure that you get the proper abrasive media. Using the wrong media can result in ineffective application and a ruined surface. Most often parts surfaces used in vapor blasting cabinet applications are those of engine mounts. Engine mounts are typically susceptible to impurities such as grease and oil. A good way to ensure that you are getting the proper media to clean the parts is to identify which type of engine mount you have. If you are unsure as to what type of mount you have it is best to contact the manufacturer and ask for assistance. Typically if you are able to identify the part you need to use a custom sprayer, but if you cannot the manufacturer should be able to provide instructions. Before attempting any vapor blasting applications it is always good practice to clean the surface you are working on with compressed air. This helps to get any dust or other contaminants off the surface making it easier to apply the appropriate anodized media. Once the surface has been cleaned, you are ready to begin spraying the media and abrasives. Vapid media and abrasives will work better on polished components. Here is a post with a general information about this topic, check it out: https://en.wikipedia.org/wiki/Dry-ice_blasting.
0 Comments
Leave a Reply. |
|